Наукова електронна бібліотека
періодичних видань НАН України
періодичних видань НАН України
On application of heat-conductive plastics in LED technology
Репозиторій DSpace/Manakin
- Домашня сторінка
- →
- Фізико-технічні та математичні науки
- →
- Відділення фізики і астрономії
- →
- Semiconductor Physics Quantum Electronics & Optoelectronics
- →
- Semiconductor Physics Quantum Electronics & Optoelectronics, 2013, том 16
- →
- Semicond. Physics Quantum Electronics & Optoelectronics, 2013, № 2
- →
- Переглянути статтю
JavaScript is disabled for your browser. Some features of this site may not work without it.
On application of heat-conductive plastics in LED technology
Інший ID:
PACS 44.10.+i, 85.60.Jb
Посилання:
On application of heat-conductive plastics in LED technology / Yu.V. Trofimov, S.I. Lishik, P.P. Pershukevich // Semiconductor Physics Quantum Electronics & Optoelectronics. — 2013. — Т. 16, № 2. — С. 198-200. — Бібліогр.: 1 назв. — англ.
Дата:
2013
Переглядів:
803
Завантажень:
625
Анотація:
A comparative analysis of the characteristics of heat-conducting plastic was
performed. The results of the thermal measurements of two of the same type 3W LED
modules installed on heat sink with the same area of heat-dissipating surface made of
aluminum and heat-conducting polymer have been presented. It has been shown that the
overheating of LED module mounted on the heat-conducting polymer heat sink is
2…3 °С higher than that on the aluminum heat sink (thermal conductivity is 20 times
higher). The ranges of applicability of the heat-conducting plastics in LED technology
have been determined.
