On application of heat-conductive plastics in LED technology

Домашня сторінка
→
Фізико-технічні та математичні науки
→
Відділення фізики і астрономії
→
Semiconductor Physics Quantum Electronics & Optoelectronics
→
Semiconductor Physics Quantum Electronics & Optoelectronics, 2013, том 16
→
Semicond. Physics Quantum Electronics & Optoelectronics, 2013, № 2
→
Переглянути статтю

dc.contributor.author	Trofimov, Yu.V.
dc.contributor.author	Lishik, S.I.
dc.contributor.author	Pershukevich, P.P.
dc.date.accessioned	2017-05-26T09:57:45Z
dc.date.available	2017-05-26T09:57:45Z
dc.date.issued	2013
dc.identifier.citation	On application of heat-conductive plastics in LED technology / Yu.V. Trofimov, S.I. Lishik, P.P. Pershukevich // Semiconductor Physics Quantum Electronics & Optoelectronics. — 2013. — Т. 16, № 2. — С. 198-200. — Бібліогр.: 1 назв. — англ.	uk_UA
dc.identifier.issn	1560-8034
dc.identifier.other	PACS 44.10.+i, 85.60.Jb
dc.identifier.uri	http://dspace.nbuv.gov.ua/handle/123456789/117692
dc.description.abstract	A comparative analysis of the characteristics of heat-conducting plastic was performed. The results of the thermal measurements of two of the same type 3W LED modules installed on heat sink with the same area of heat-dissipating surface made of aluminum and heat-conducting polymer have been presented. It has been shown that the overheating of LED module mounted on the heat-conducting polymer heat sink is 2…3 °С higher than that on the aluminum heat sink (thermal conductivity is 20 times higher). The ranges of applicability of the heat-conducting plastics in LED technology have been determined.	uk_UA
dc.language.iso	en	uk_UA
dc.publisher	Інститут фізики напівпровідників імені В.Є. Лашкарьова НАН України	uk_UA
dc.relation.ispartof	Semiconductor Physics Quantum Electronics & Optoelectronics
dc.title	On application of heat-conductive plastics in LED technology	uk_UA
dc.type	Article	uk_UA
dc.status	published earlier	uk_UA