Домашня сторінка
→
Фізико-технічні та математичні науки
→
Відділення фізико-технічних проблем матеріалознавства
→
Functional Materials
→
Functional Materials, 2017, том 24
→
Functional Materials, 2017, № 3
→
Перегляд Functional Materials, 2017, № 3 за датою випуску

Перегляд Functional Materials, 2017, № 3 за датою випуску

Результати 1-20 з 25

Наступна сторінка

Properties of Ni-TiO₂ composites electrodeposited from methanesulfonate electrolyte

Sknar, Yu.E.; Savchuk, O.O.; Sknar, I.V.; Danilov, F.I. (Functional Materials, 2017)

The effect of conditions of preliminary preparation of methanesulfonate suspension electrolyte used in electrodeposition of Ni-TiO₂ composites, on the aggregate stability of the dispersed phase is studied. It has been found ...
Sensitivity analysis and proportioning design of rock burst similar materials

Yongsheng Liu; Jin Li; Qiulan Wu; Wang Liu (Functional Materials, 2017)

The rock burst similar material were prepared by quadratic orthogonal design. Sand ratio (A), cement plaster ratio (B), watered rate (C) are used as the level influence factors, and the uniaxial compressive strength C, the ...
Internal stresses and magnetic properties of Fe-Co electrolytic coatings

Proskurina, V.O.; Yermolenko, I.Yu.; Zyubanova, S.I.; Shipkova, I.G.; Avramenko, B.A.; Sachanova, Yu.I. (Functional Materials, 2017)

Consideration was given to the effect of electrolysis parameters on the composition and the properties of electrolytic iron-cobalt film coatings obtained from citrate electrolytes. The interconnection between the film ...
Interaction of Portland cement hydration products with complex chemical additives containing fiberglass in moisture-proof cement compositions

Demina, O.I.; Plugin, A.A.; Dedenyova, E.B.; Bondarenko, D.O.; Kostuk, T.A.; Bondarenko, A.I. (Functional Materials, 2017)

Physicochemical studies of interaction of the hydration products of Portland cement with the complex chemical additives, which ensure the penetrating action of moisture-proof cement compositions with the borosilicate ...
Preparation and characterization of mortar mixes containing organic acid/expanded vermiculite composite PCM

Xinzhong Zhang; Weizhun Jin; Yajun Lv; Haibin Zhang; Weibing Zhou; Fangyi Ding (Functional Materials, 2017)

In this paper, capric acid (CA) and palmitic acid (PA) binary PCM/expanded vermiculite (CA-PA/EVM) form stable composite PCM (FS-CPCM) was firstly synthesized by adsorption method. The EVM had the optimal adsorption rate ...
Macroscopic simulation of atom-sized structures of functional materials: phenomenology of the elongated electrode system

Pospelov, A.P.; Kamarchuk, G.V.; Savytskyi, A.V.; Sakhnenko, M.D.; Ved', M.V.; Vakula, V.L. (Functional Materials, 2017)

A new phenomenological approach is proposed to formalize "the elongated element" as electrochemical medium in which electrode reactions are localized on the surface of an elongated first-class conductor with the outline ...
Research on game scheduling of galvanizing pipe production

Yingying Li; Shaohua Dong (Functional Materials, 2017)

In this paper, we analyze and integrate the production process of "hot-dip galvanized steel pipe", the main product in the case enterprise and builds a model for the production scheduling with Cooperative Game Theory from ...
Study on cutting performance and tool wear of micro-textured tool for milling Ti6Al4V

Shen Xiang-yu; Guo Xu-hong; Deng Da-song; Lu Li-li; Chen Ya-dong (Functional Materials, 2017)

The research found that the surface texture applied to the cutting tool could improve the frictional states of tool-chip and tool-workpiece effectively. In order to study the technology of surface texture how to effect the ...
Structural aspects of the phase and texture formation processes in thin-layer Ni-W/TiN systems which are perspective for creating high-temperature superconductors of the second generation

Sunhurov, M.S.; Derevyanko, V.V.; Leonov, S.A.; Sukhareva, T.V.; Finkel, V.A.; Shakhov, Yu.N. (Functional Materials, 2017)

The investigation objective is searching for the new ways of controlling the structural properties of paramagnetic substrates for creating the high temperature coated superconductors for power applications. Processes of ...
Investigations on temperature dependences of parameters of ¹²⁷I NQR spectrum of (BiI₃)(₁₋ₓ)(PbI₂)ₓ mixed layered semiconductor and alkaline halogens crystals

Vertegel, I.G.; Chesnokov, E.D.; Ovcharenko, O.I.; Vertegel, I.I.; Ivanov, O.S.; Gnatenko, Yu.P.; Ponkratenko, O.A. (Functional Materials, 2017)

Results of investigations of the temperature dependence of NQR frequencies in the temperature range of 4.2-150 K for ¹²⁷I and ⁷⁹Br of the (BiI₃)(₁₋ₓ)(PbI₂)ₓ mixed layered semiconductor and the crystals of alkaline halogens ...
Distribution peculiarities of stray fields and magnetization near magnet singularities

Samofalov, V.N.; Belozorov, D.P.; Ravlik, A.G.; Aseev, A.S. (Functional Materials, 2017)

Distributions of both magnetization and stray fields near singularities of a permanent magnet with high uniaxial anisotropy have been studied. On the basis of calculations it is shown that in magnets with high magnetic ...
Layered crystals FeIn₂Se₄, In₄Se₃ and heterojunctions on their basis

Kushnir, B.V.; Kovalyuk, Z.D.; Katerynchuk, V.M.; Netyaga, V.V.; Tkachuk, I.G. (Functional Materials, 2017)

A new heterojunction (GP) p-FeIn₂Se₄-n-In₄Se₃ was formed by the mechanical contact of the FeIn₂Se₄ plate with the van der Waals surface of In₄Se₃. Investigation of Volt-Farada's, spectral characteristics and temperature ...
Sapphire subdivision at different heat treating types

Brodskii, R.Ye.; Konevskiy, P.V.; Safronov, R.I.; Voloshin, A.V. (Functional Materials, 2017)

In the work the results of experimental investigation of fragmentation of sapphire samples subjected to various types of heat treating are given. It was studied the fragmentation of the samples subjected to short and long ...
Liquid crystal dispersions containing nanoparticles of different anisometry: carbon nanotubes and organomodified laponite

Samoilov, A.N.; Minenko, S.S.; Lisetski, L.N.; Solovyova, E.A.; Lebovka, N.I.; Vistak, M.V. (Functional Materials, 2017)

Optical transmission and optical microscopy studies have been carried out for dispersions of organomodified laponite in cholesteric liquid crystal (CLC) matrices. Laponite samples with different degree of exfoliation, ...
Using cyanine dye J-aggregates as luminescence probe for nanostructured media

Sorokin, A.V.; Ropakova, I.Yu.; Borovoy, I.A.; Bespalova, I.I.; Yefimova, S.L. (Functional Materials, 2017)

Due to excitonic nature of electronic excitations in J-aggregates causing the unique spectral properties they successfully applied as luminescent probes in biology. In present report we demonstrate a possibility using ...
GdVO₄:Eu³⁺ nanoparticles - embedded CaCO₃ microspheres: synthesis and characterization

Bespalova, I.I.; Yefimova, S.L.; Tkacheva, T.N.; Hubenko, K.A.; Sorokin, A.V.; Mateychenko, P.V. (Functional Materials, 2017)

In present study, we report on synthesis of fluorescent GdVO₄:Eu³⁺ nanoparticle-embedded CaCO₃ microparticles (CaCO₃@GdVO₄:Eu³⁺) and their characterization. Synthesized CaCO₃@GdVO₄:Eu³⁺ microspheres are of vaterite polymorph ...
Potential producers of biogenic magnetic nanoparticles among disease-producing microorganisms of the brain

Gorobets, S.V.; Gorobets, O.Yu.; Darmenko, Y.A. (Functional Materials, 2017)

In this paper, microorganisms-causative agents of brain disease have the potential to produce biogenic magnetic nanoparticles (BMN), which can accumulate in the human brain in addition to BMN, which are biomineralized in ...
Biogenic magnetic nanoparticles in lung, heart and liver

Gorobets, S.V.; Gorobets, O.Yu.; Medviediev, O.V.; Golub, V.O.; Kuzminykh, L.V. (Functional Materials, 2017)

The main purpose of this research is to find new human organs and tissues where BMN biomineralization can take place to prevent BMN accumulation, which can lead to side effects during drug delivery.
Obtaining urea-formaldehyde foam materials with improved mechanical properties

Rymar, T.E.; Unkovskaja, V.V. (Functional Materials, 2017)

The article presents the results of study of gas-filled material macrostructure based on urea-formaldehyde resin and liquid glass granular filler, obtained by chemical foaming using a variety of the gas-generating agents. ...
The experimental research on axial compression performance of concrete-filled steel square tube strengthened by internal transverse stiffened bars

Nan Li; Lai Wang; Yajun Xi; Hui Wang; Tong Guan; Furui Dong; Changfeng Sui; Wenbin Cui (Functional Materials, 2017)

The application of Concrete-filled square steel tubular column in structural engineering is more and more widely. In order to improve the confinement of concrete core, the configuration of concrete-filled square steel tube ...

Результати 1-20 з 25

Наступна сторінка

Пошук

Розширений пошук

Перегляд

Вся бібліотека
Колекція

Перегляд Functional Materials, 2017, № 3 за датою випуску

Репозиторій DSpace/Manakin

Перегляд Functional Materials, 2017, № 3 за датою випуску

Пошук

Перегляд

Вся бібліотека

Колекція

Мій обліковий запис