Наукова електронна бібліотека
періодичних видань НАН України
періодичних видань НАН України
Application of Stir Tool Force Measuring Dynamometer for Friction Stir Welding of Aluminum Alloys
Репозиторій DSpace/Manakin
- Домашня сторінка
- →
- Фізико-технічні та математичні науки
- →
- Відділення механіки
- →
- Проблемы прочности
- →
- Прoблемы прочности, 2017
- →
- Проблемы прочности, 2017, № 1
- →
- Переглянути статтю
JavaScript is disabled for your browser. Some features of this site may not work without it.
Application of Stir Tool Force Measuring Dynamometer for Friction Stir Welding of Aluminum Alloys
Інші назви:
Применение динамометра к измерению усилия устройства перемешивания при сварке трением для алюминиевых сплавов
Тема:
Научно-технический раздел
УДК:
539.4
Посилання:
Application of Stir Tool Force Measuring Dynamometer for Friction Stir Welding of Aluminum Alloys / H.F. Wang, J.L. Wang, D.W. Zuo, W.W. Song // Проблемы прочности. — 2017. — № 1. — С. 181-189. — Бібліогр.: 12 назв. — англ.
Підтримка:
This study is supported by the National Natural Science Foundation of China (Grantes Nos. 51175255 and 51305199); the Excellent young talents fund key project of the Anhui Higher Education Institutions of China (Grant No. 2013SQRL089ZD); and the Starting Foundation for Talents from Huangshan University of China (Grant No. 2013xkjq003).
Дата:
2017
Переглядів:
318
Завантажень:
292
Анотація:
In this study, a stir tool force measuring dynamometer was designed and manufactured to be suitable for use during the process of friction stir welding. The dynamometer meets the requirements needed for actual force measurements, with error percentage values in the x-, y-, and z-axis directions of 1.1, I.3, and 1.2%, respectively, and a three-directional sensitivity range of 0.4-2.1%. At the same time, stir tool forces were measured under different process parameters using the manufactured dynamometer. The stir tool force mathematical model, to be used for friction stir welding processes, was established by function approximation and regression analysis methods. The model was set up with a significance level under 90%. Finally, a comparison between the model-calculated values and experimental values yielded a stir tool force average error of 10.4, 4.66,, and 7.11% in the x, y, and z axes direction, respectively. Therefore, calculated and experimental values are in agreement.
