Перегляд за темою "Technology"

Результати 41-60 з 263

Deagglomeration of aerosil in polishing suspension for chemical-mechanical polishing of sapphire

Vovk, E.A. (Functional Materials, 2015)

Studied is the influence of pH, surface-active substances and ultrasonic dispersing on the degree of deagglomeration of aerosol in the polishing suspensions used for CMP of sapphire, the removal rate and the optical quality ...
Dependence of PbMoO₄ crystal damage threshold on Nd³⁺ concentration and method of doping

Baumer, V.N.; Gorobets, Yu.N.; Gudzenko, L.V.; Kosmyna, M.B.; Nazarenko, B.P.; Puzikov, V.M.; Shekhovtsov, A.N.; Shtitelman, Z.V. (Functional Materials, 2010)
Determination of side products of stilbene synthesis by gas chromatography and chromato-mass spectrometry

Averin, V.A.; Aruslanova, R.I.; Budakovsky, S.V.; Volkov, V.L.; Vashchenko, V.V.; Knyazeva, I.V. (Functional Materials, 2008)

The impurity composition of trans-stilbene obtained by synthesis and purified by various techniques has been studied using combination of gas chromatography and chromato-mass-spectrometry. The results obtained made it ...
Determining the technological mode of foaming of blocked heat-insulating material based on liquid glass in microwave equipment

Rymar, T. (Functional Materials, 2018)

The foaming process of liquid glass composition during production of blocked heat-insulating material based on liquid glass in the microwave equipment has been researched. The optimum conditions for obtaining he heat-insulating ...
Development of back contact for CdS/CdTe thin-film solar cells

Khrypunov, G.; Meriuts, A.; Klyui, N.; Shelest, T.; Deyneko, N.; Kovtun, N. (Functional Materials, 2010)
Development of new composite scintillators based on organic single crystal grains

Karavaeva, N.L.; Tarasenko, O.A. (Functional Materials, 2009)

The proposed organic composite scintillators contain crystalline grains of stilbene or p-terphenyl incorporated into a two-component non-scintillating polymer matrix. Discussed are the technological aspects of the making ...
Development of new compositions of ceramic masses in SrO-Al₂O₃-SiO₂ system

Lisachuk, G.V.; Kryvobok, R.V.; Zakharov, A.V.; Chefranov, E.V.; Lisachuk, L.N. (Functional Materials, 2017)

The paper considered promises for creation of radio-ceramic ternary SrO-Al₂O₃-SiO₂. Predictive analysis on capabilities of synthesis of radiotransparent ceramic strontium anorthite non-stoichiometric composition was conducted ...
Directed phase formation of functional glass-crystalline coatings for ceramics in TiO₂-Al₂O₃-SiO₂ system

Lisachuk, G.V.; Bilostotska, L.O.; Trusova, Yu.D.; Vernygora, K.P.; Podchasova, K.V.; Krivobok, R.V. (Functional Materials, 2015)

Possibility of obtaining of thin crystallization (less than 4 μm) of non-fritt coatings by adding significant number (up to 15 wt.%) of tin dioxide (SnO2₂) to their compounds was studied. It was found that titaniferous ...
Dispersion and their tribological properties of molybdenum nanoparticles with different particle sizes as additive in lubricating oil

Tianhua Chen (Functional Materials, 2018)

Using silane coupling agent KH-570 as the surface modifier-molybdenum nanoparticles with various particle sizes were prepared by mechanical ball milling method. The molybdenum nanoparticles with different particle sizes ...
Double-layer ITO/Al back surface reflector for single-junction silicon photoconverters

Kopach, V.R.; Kirichenko, M.V.; Shramko, S.V.; Zaitsev, R.V. (Functional Materials, 2008)

It has been shown that to increase the efficiency and manufacturability of single-crystal silicon photovoltaic solar energy converters (Si-PVC) with 180-200 μm thick base crystals having a polished photoreceiving surface ...
Effect of CO₃²⁻ and OH⁻ impurities on thermal growing conditions of large-size NaI:Tl crystals and their quality

Kudin, K.A.; Kolesnikov, A.V.; Zaslavsky, B.G.; Kudin, A.M.; Mitichkin, A.I.; Vasetsky, S.I.; Voloshko, A.Yu.; Sofronov, D.S.; Shishkin, O.V. (Functional Materials, 2011)
Effect of CuS, Mn₃O₄ and CeO₂ additives on Co(II) sorption by ZnS particles

Sofronov, D.S.; Oreshina, A.O.; Bryleva, E.Yu.; Sofronova, E.M.; Mateichenko, P.V.; Puzan, A.N. (Functional Materials, 2017)

ZnS particles modified with Mn₃O₄, CeO₂ and CuS were obtained from aqueous solutions. It was shown that addition of copper and manganese ions into the reagent mixture doesn't have any influence on particle formation from ...
Effect of different particle size reduction techniques on the nefopam and aciclovir dispersity

Pinchukova, N.A.; Lyapunov, N.A.; Bezuglaya, E.P.; Voloshko, A.Yu.; Lyapunov, A.N.; Merko, M.A.; Chebanov, V.A. (Functional Materials, 2015)

Presents the results of application of different particle size reduction approaches to the drug substances - aciclovir and nefopam, namely, wet milling, ultrasonic (US) dispergation, US crystallization and US antisolvent ...
Effect of growth atmosphere composition on heat and mass transfer at continuous feed growth of scintillation crystals from melt

Tymoshenko, M.M.; Goriletsky, V.I.; Vasyliev, V.V.; Sumin, V.I.; Sidletskiy, O.Ts.; Ilyashenko, T.O. (Functional Materials, 2008)

Effect of the furnace atmosphere composition on the heat and mass transfer has been studied when growing Csl(Na) crystals of 300 mm dia. under control of the crystal-melt interface (CMI) and the crystal immersion depth ...
Effect of growth atmosphere on Ce³⁺ incorporation in Gd₂SiO₅ single crystals

Bondar, V.G.; Krivoshein, V.I.; Martynov, V.P.; Nagornaya, L.L.; Sideletskiy, O.Ts. (Functional Materials, 2007)

Peculiarities of oxide crystal growth by the Czochralski technique have been discussed in the present paper. A correlation between oxygen content in the growth atmosphere and the Ce³⁺ incorporation coefficient at growing ...
Effect of microwave sintering temperature on structure and properties of bioceramics based on biogenic hydroxyapatite

Tovstonoh, H.; Sych, O.; Skorokhod, V. (Functional Materials, 2014)

The present work demonstrates the possibility to produce medicine-aimed ceramics on the basis of biogenic hydroxyapatite with structural-mechanical properties required for replacement of the bone tissue defects using ...
Effect of nano-SiO₂ and lime on characteristics and mechanical properties of coastal clay

Wentao Shang; Zhong Liu; Yuqin Gao (Functional Materials, 2019)

In this study, the effect of nano-SiO₂ and lime on the characteristics and mechanical properties of coastal clay were investigated. The California bearing ratio (CBR) test and hydraulic conductivity tests were performed ...
Effect of oxidation method of cadmium and zinc chalcogenide substrates on physical properties of CdO and ZnO heterolayers

Makhniy, V.P.; Boiko, Yu.N.; Skrypnyk, N.V.; Slyotov, M.M.; Khusnutdinov, S.V. (Functional Materials, 2009)

Formation of CdO and ZnO heterolayers on cadmium and zinc chalcogenide substrates by oxidation and effect of the formation method on physical properties of the oxides are discussed.
Effect of sintering conditions on physical properties of carbonated hydroxyapatite ceramics

Tkachenko, M.V.; Zyman, Z.Z. (Functional Materials, 2008)

The carbonated hydroxyapatite powder was obtained by reaction of calcium carbonate with ortho-phosphoric acid. The compacted powder samples were sintered in the 800- 1000°C range in dry carbon dioxide atmosphere under ...
Effect of technology parameters on the quality of nZnSe(X)/Ni Schottky diodes

Katrunov, K.A.; Galchinetskii, L.P.; Grinyov, B.V.; Starzhinskiy, N.G.; Bendeberya, G.N.; Bondarenko, E.A. (Functional Materials, 2008)

Effect of technology parameters on the quality of nZnSe(X)/Nl Schottky's surface barrier structure used as components of UV photosensitive detectors are studied. Both the spectrum and the total sensitivity of photodiodes ...

Результати 41-60 з 263

Пошук

Розширений пошук

Перегляд

Вся бібліотека

Перегляд за темою "Technology"

Репозиторій DSpace/Manakin

Перегляд за темою "Technology"

Пошук

Перегляд

Вся бібліотека

Мій обліковий запис